Our Products
  Car Cradle
算 Products 算 Car Cradle 算 Smartphone Cradle 算
ST-06MG

Magnetic  Mount (ST-06MG)

 

DIGIDOCK Magnetic Dashboard Mount is a powerful magnetic mount with thorough force of attraction and an automotive grade 3M (VHB) adhesive tape at the bottom that holds your device on many flat surfaces. Full 360-degree rotation allows you to view your phone from any desired angle while keeping your hands on the wheel.

 

The magnetic mount aims to provide a permanent and also convenient mounting system. It is designed to be petite and simple so that it doesnt look awkward on your dash board. More, thanks to the powerful force of attraction, it can hold up all phone sizes, light tablets, and mobile devices. In other words, mounting can be so easy and direct by just snapping on and off!


Features

360 DEGREE SWIVEL Same as our other product, its important to choose how you want to glance at your phone by adjusting ball joint.

SMALL AND SIMPLE Silver aluminum bezel provides an elegant look when you leave it alone on the dashboard.

GREAT DURABILITY It can hold up all phone sizes, light tablets, and mobile devices. Its time to swiveling or rotating your phone without falling off!

POWERFUL MAGNETS The gadget comes with strong magnets providing the best force of attraction; the swift-snap holder allows you to snap on and off your device easily.


3M ADHESIVE BASE (VHB) The mount is very easy to be stuck onto many smooth surfaces and it will stay firmly in place regardless of any road impact.

COMPATIBLE WITH MANY SURFACES Use it in your bedroom, office, car, kitchen, bathroom vanity or simply anywhere you prefer.

 

(*Note: The 3M adhesive does not support some

 rough/leather surfaces properly.

When install, please press firmly about

1-2 minutes, and better wait up to 24 hours

before attach any device.)

 

 


Dimensions



Magnet:

-Diameter 36.8 mm

 

Accessories:

-Round black metal plate+3M adhesive (diameter: 38m)

-Rectangular black metal plate (66*40.5mm)

-Clear film (47*47mm)





Instruction

1.  Remove the red backing of the 3M adhesive and tick on your desired flat surface.

(*Note: The 3M adhesive does not support some rough/leather surfaces properly. When install, please press firmly about 1-2 minutes, and better wait up to 24 hours before attach any device.)

2. Adjust your desired angle by rotating the turning knob.

3. Place the metal plate within the case, or stick the metal plate directly onto the back of your phone. Please note that the adhesive tape is suggested to be used only once.

4. Snap on your phone and find your perfect viewing angle.


 
All intellectual property rights, including without limitation to copyright and trademark of this work and its derivative works are the property of, or are licensed to,
Digidock Development Inc. Any unauthorized use is strictly prohibited.